|
Contact Information
Telephone
+32
(0)3 722 91 60
Fax
+32
(0)3 722 91 66
Postal
address
Zakstraat
104
9112
Sinaai
Belgium
Electronic
mail
info@proxtech.com
|
| |
|
|
The
ULTRA reader offers a very flexible solution for flush mount
applications. The reader is designed for simple installation into a 55mm
switchbox. This reader comes in a fully potted housing containing all the
electronics required to read an RFID transponder and output the code in
a number of formats. Due to the fully potted housing, the reader can be
installed both indoors and outdoors.
An
8-way connector on the back of the unit is provided to connect the unit
to a controller.
A
three-colour LED indication and audible tone enhance user feedback. The
unit also allows for user control of two of the three LEDs and the beeper.
A
number of possible output formats is available and can be selected at
time of ordering.
The ULTRA reader is
available in 2 versions :
-
ULTRA-EM
: a 125 kHz reader, supporting transponder types EM4x02, Hitag 2 in
Public Mode A, TEMIC e5550 and equivalent devices.
-
ULTRA-MF
: a 13,56 MHZ Mifare UID reader
|
Technical specifications ULTRA-EM
& ULTRA-MF
- Dimensions: 48
mm x 48 mm x 37mm (excluding mounting plate)
- Supported
transponder types :
- on 125
kHz : 40
bit read only transponders (EM4x02 family, HiTag2 Public Mode A,
TEMIC e5550 and equivalent)
- 13,56
MHz : Mifare® Std (Contactless
interface as per spec ISO/IEC 14443 Type A)
- Interface: ( select one when ordering )
- Wiegand (42
bits, 34 bits or 26 bits)
with selectable Impulse Width and Impulse Interval
- Clock
& Data (13, 10 or 8 characters)
- TTL
(9600, 4800 or 2400 Bd)
- Customer
specific interfaces available on request
- Read range with
internal antenna ( values depending on transponder types, power supply
and ambient
environment )
- on
125 kHz up to 100 mm
- on 13,56
MHz up to 50 mm
- Power supply
: 8 to 13.6 Vdc / 110 mA typ.
- Indications : 3 LEDs ( red / yellow / green ) +
buzzer
- Wiring : 8-way
connector located on the back of the unit
- Protection
rate : IP65 ( depending on mounting method )
- Operating
temperature : -20°C to +60°C
- Integrated
antenna and electronics
- Mounting :
simple flush-mount installation into a 55mm switchbox
- Fully potted
housing allows easy installation both in- as outdoor
|
